Anybody who has installed one themselves or had one installed professionally absolutely loves the fact they have chosen to switch to a tankless water heater. While they can be a bit trickier to install than a standard hot water heater, it can still be done by oneself. Here are some expert tips to follow while attempting tankless hot water Heater Installation in Plymouth.
Different Parts
As a rule of thumb, tankless hot water heaters require different sized parts than do their traditional counterparts. The diameter of the gas supply lines will be larger, the power supply will be of a higher voltage, and a dedicated stainless-steel flue will be required. Keep these things in mind when deciding to attempt this project alone. Specialized union connector sets should also be purchased for the water supply. This will allow bypass capability and will easily allow delimiting maintenance if it is needed in the future.
Supply
Firstly, the water supply needs to be turned off. After this is completed, it will be necessary to disconnect the water hose from the old tank to the new heater. There will be a bit of water left in the hose even after the water has been turned off so be sure to put a bucket underneath to catch any spillage. Next, disconnect the source of heat from the old tank. This is done by either closing the valve if it is heated by gas or unplugging it from the wall if it is heated by electricity.
Disposal & Installation
After the old heater is disconnected from its power source, it will need to be disposed of. Different cities have different environmental laws so be sure to check which apply to the particular location. Now it is time for tankless Heater Installation in Plymouth. It will be mounted to the wall so be sure to follow all building codes applicable to the area in which it will be used. If the codes are not known, a professional installation company such as Sabre Heating & Air Conditioning can always be consulted. Hook up the water supply lines according to the directions which came in the packaging for the heater. After this is done, it is time to hook the heater up to the heat source. Again, this can be done by following the included instructions.
Visit the website for more information about installing tankless water heaters.
